so, i am trying to get my lighting up and running after the motor swap and am trying to integrate the wiring.
i found it is mush easier to use what is there in stead of reinventing the wheel (go figure). so here is my issue.
in the original jeep wiring i had to rewire some things because of bad previous owner wiring but thanks to diagrams i have got the hazard/brake lights working...sorta.
what is happening is in the beginning the passenger brake light would not work, so after rewiring it they both worked fine, went in had dinner then my daughter came out with me while i finished buttoning things up and pressed the brake and the driver brake light was not working so i took all the old wiring out of that side and rewired it...worked fine. came out the next morning to finish that and some other things and the passenger side was not working again :x so instead if tearing it all apart again i started with the tester ant to make this long story short(er) there is no power to the passenger side brake light (it is a dark brown wire) all the way up to the connector up to the dash.
is this a sign of the turn/hazard switch assembly going bad?
any other thoughts would be appreciated
i found it is mush easier to use what is there in stead of reinventing the wheel (go figure). so here is my issue.
in the original jeep wiring i had to rewire some things because of bad previous owner wiring but thanks to diagrams i have got the hazard/brake lights working...sorta.
what is happening is in the beginning the passenger brake light would not work, so after rewiring it they both worked fine, went in had dinner then my daughter came out with me while i finished buttoning things up and pressed the brake and the driver brake light was not working so i took all the old wiring out of that side and rewired it...worked fine. came out the next morning to finish that and some other things and the passenger side was not working again :x so instead if tearing it all apart again i started with the tester ant to make this long story short(er) there is no power to the passenger side brake light (it is a dark brown wire) all the way up to the connector up to the dash.
is this a sign of the turn/hazard switch assembly going bad?
any other thoughts would be appreciated
Comment