Tweet
recently some one on face book was looking for the wiring harness and connector to their sway bar disconnect because mud had gotten into the connector and completely ruined the connector and shorting out the electrical wiring blowing fuses for the sway bar and lockers.the connector was trashed.
So be aware that this connector is NOT water proof and mud will seriously damage you wiring and the connector .
I had the connector and wiring left over from when I bought the wiring harness to use when I installed my Rubicon axles.this wiring harness was $130.00 and would take many hours labor to replace
Moral if you have a Rubicon stay out of the deep mud or fined a way to seal the connector to make it water tight.If you have been in deep mud unlatch your connector check and clean as required
So be aware that this connector is NOT water proof and mud will seriously damage you wiring and the connector .
I had the connector and wiring left over from when I bought the wiring harness to use when I installed my Rubicon axles.this wiring harness was $130.00 and would take many hours labor to replace
Moral if you have a Rubicon stay out of the deep mud or fined a way to seal the connector to make it water tight.If you have been in deep mud unlatch your connector check and clean as required